youngberg1950
@youngberg1950
Eminent Member
Joined: Dec 11, 2012
Topics: 1 / Replies: 36
Reply
RE: PixaString Wiring

Has any one else noticed that the GND and VCC are rolled on these compared to the Pixabulb? I tried to connect a string to the output of the pixabulbs...

11 years ago
Reply
RE: DIY LED Express 2015 Pre-Sale Announcement!

Stormyblade wrote:Thank you very much for the update. Just remember, my last name starts with 'B' and if you are going alphabetically...:biggrin: To...

11 years ago
Reply
RE: Pixel Conversion for RobG 10W RGB Driver Board

RobG wrote:I need two more testers with GB floods and e682. Rob, I completed the following tests: Sandevices e6804 tested GOOD Falcon Christmas US...

12 years ago
Reply
RE: DIY LED Express 2015 Pre-Sale Announcement!

From the first post on this thread: tjetzer wrote:Official Pre-Sale Announcement: The first DIY LED Express LLC Pre-Sale will run from January 2nd t...

12 years ago
Reply
RE: Pixel Conversion for RobG 10W RGB Driver Board

RobG wrote:That should work, pm me your email and shipping address You mailbox is full

12 years ago
Reply
RE: Pixel Conversion for RobG 10W RGB Driver Board

I have 10 of the round 2 group buy floods built and tested. I have the e6804 if that's close enough. Sent from my SPH-D710 using Tapatalk

12 years ago
Reply
RE: 10W RGB LED Driver Board and BOM Group Buy, ROUND 2

Looks like it will barely fit. I don't have an assembled RF_1 here. They are all in storage. This is a PCB that I started to assemble and I've placed...

12 years ago
Forum
Reply
RE: 10W RGB LED Driver Board and BOM Group Buy, ROUND 2

I have one of those on my work bench at home. I'll try an RF_1 in it when I get home tonight. If it fits I'll be pissed... I bought 10 of the old styl...

12 years ago
Forum
Reply
RE: Wireless DMX RGB Controller

Yep I overlooked the Ren4Flood piece..... My Bad! I also bought the 120V AC warm white floods with the "transformer" in the back. The problem is tha...

12 years ago
Reply
RE: Wireless DMX RGB Controller

I'm playing with the idea of using a Komby RF_1_12 for the wireless part. I'm going to test using the RF_in_RGB_out but not use his RGB shield. I'll j...

12 years ago
Reply
RE: Sad, but it looks like the end of Radio Shack is finally here !

I went into my local RS a couple weeks ago and all of the cell phones were gone and they had signs up with everything 25 - 50% off. I went back a few...

12 years ago
Forum
Reply
RE: 10W RGB LED driver board

Rob, That sounds great to me! I can't wait until you have them ready. Doug RobG wrote:Doug, the board is so small, it will fit even under the reflec...

12 years ago
Reply
RE: 10W RGB LED driver board

RobG, Will the dmx-rgb boards fit in the back cover of the "standard" 10 watt flood housing? Sorry if this was already answered. I scanned this thr...

12 years ago
Reply
Reply
RE: 10W RGB LED driver board

Rob, How do you set the address on the DMX boards? Doug Sent from my GT-P5110 using Tapatalk

12 years ago
Page 1 / 3