Notifications
Clear all

Bad pixel

26 Posts
12 Users
0 Reactions
4,880 Views
Posts: 215
Topic starter
(@jdesign21)
Reputable Member
Joined: 13 years ago

I had to replace 4 blue pixels today. So far this season it has been over 20 of them that turn blue. I notice it happens after it rains.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Put a drop of Corrosion-X gun oil on each contact. That will keep the moisture out of the connectors and prevent corrosion.


Reply
Posts: 418
(@richienorthcott)
Reputable Member
Joined: 7 years ago

As in they light up 'blue' rather than the colour you're sending? Yes I have seen that too. I'm thinking maybe some brand of pixel aren't as moisture proof as they should be.... I couldn't tell you where I got mine, I usually go with whatever's cheapest on AliExpress. I did notice the pixels I bought this year had a slightly larger outside diameter, also the plastic material was much more rigid. These ones haven't given me any issues (yet) but it was frustrating since I'd CNC'd my props to fit the size I was expecting.


Reply
joeytx
Posts: 249
(@joeytx)
Reputable Member
Joined: 19 years ago

I had to switch to all bullet pixels versus the square nodes. The square ones invariably will lose their seal and fail. I sprayed sealant on the backs, and tried Corrosion-X, but it didn't stop the failures. I bought 5000 new bullet pixels from Ray this year, and so far only 2 have failed.

Joey


Reply
Posts: 544
(@jllracer55)
Honorable Member
Joined: 13 years ago
MartinMueller2003 wrote:I also purchased 2000 pixels from Ray Wu at about that the same time and had to spend time every day fixing the strings. I thought it was PSUs, nope. Wiring, nope. I finally pulled them out of the show and replaced them. Just about ANY vendor would give you getter results.
I went to ebay and purchased 2000 of these: https://www.ebay.com/itm/164693553277?mkevt=1&mkpid=0&emsid=e11051.m43.l1123&mkcid=7&ch=osgood&euid=06f1b5ad68a248499516f7c337705c17&bu=42954339803&osub=-1%7E1&crd=20221027201452&segname=11051

After my initial shock that they had marked the arrow in the opposite direction of all of my other strings, I tested and deployed them. I have had 1 pixel out of the 2000 pixels fail in the past three months of daily testing and display. I am not seeing any other issues with them so far. We will see how the hold up over the summer in the shed.

How is the wire Guage on those pixels? Is it 18awg?

Sent from my SM-A716U using Tapatalk


Reply
Page 2 / 6
Share: