Bob Moody wrote:As a gece controller really no better or worse than the EEv3 controller.
I would suggest running the e6804 with the ws2811 pixels with your lor sequence. If you still see the same problems as before, it probably is a problem with lor.
Ok here's a few more tests I ran on the ws2811/ws2812 code. I used the SACNView test output and it ran fine with a string of 50 pixels (no jitter or missing frames). So it appears the enc28j60 can keep up with a 40hz refresh rate. When I ran the same test with the GECE pixels, you could see jitter/dropped frames, which I would attribute to the slow refresh rate of the GECEs. This was the case even after I sped up the timing of the GECE output, which should have allowed for a refresh rate greater than 40hz. The GECE code works fine for 20hz but not 40hz (at least for a string of 36). This would also explain why Bob was seeing the problems in LOR with the GECEs, since it seems to output pixel data at a rate of 40hz.
I need to load vixen and see exactly how many universes of pixel data the enc28j60 can handle at a 40hz refresh rate. Or maybe I can try the new xlights software, since it supports a faster refresh rate.
