Confirm 2811 wiring
 
Notifications
Clear all

Confirm 2811 wiring

7 Posts
4 Users
0 Reactions
1,945 Views
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago
[#31001]

I have a number of ws2811 strings, using Red, White & Green wires.
Can some confirm the following
Red - +5v
Green - data in/out
White - ground (0v)

Thanks

Sent from my SM-N9005 using Tapatalk


6 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

ok this is what I did turn them over and look at bottom you will see inside the solder points of them v+ (positive) di (data wire) and gnd for (ground) I use my magnifier the colors depend on who wired them so always look inside and check I have 2 different sets 1 has red green and white wires the other is red blue and green and you can also look at the chip and see an arrow that tells you which way the data flow is so you connect too start of string not the wrong end on my new ws2811 the wires are as stated red + / green data / white - but check always don't wanna burn them out


Reply
gdyrdave
Posts: 916
(@gdyrdave)
Noble Member
Joined: 16 years ago

I agree with James. Maybe a photo of the pixels would help us.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

I am pretty sure I have got it right. It is just that every code port I have tried still doesn't make the buggers work. The back side of the pcb is marked DO.

Sent from my SM-N9005 using Tapatalk


Reply
Posts: 1744
(@tjetzer)
Noble Member
Joined: 18 years ago
Matt_Edwards wrote:I am pretty sure I have got it right. It is just that every code port I have tried still doesn't make the buggers work. The back side of the pcb is marked DO.

Sent from my SM-N9005 using Tapatalk

Are you sure you have the input side of the string connected to the output side of the controller?


Reply
gdyrdave
Posts: 916
(@gdyrdave)
Noble Member
Joined: 16 years ago

From what you said the connection DO is the output side of the Pixels. You need the other side that says DI.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

use a magnifier and look at back of pixel you should see an arrow the power flows the way the arrow is pointing if arrow is pointing up the power comes in bottom if arrow is pointing down the power comes in top and so on depends on how you hold them looking at mine the input side is gnd / di / v+ the output side is gnd / do / v+ the arrows make the different power / data / gnd into pixel (-->) power / data/ gnd out too next pixel out so if your input is saying do you are going in wrong end of string


Reply
Share: