5V pixels flashing ...
 
Notifications
Clear all

5V pixels flashing problem

8 Posts
5 Users
0 Reactions
2,361 Views
Posts: 4
Topic starter
(@vgehts)
Active Member
Joined: 12 years ago
[#39152]

I'm having some problems with 5V pixel strands. I don't have this problem with 12V strands. I've been reading through several articles online about maybe the need for power injection, but hooking both the beginning and ending of a strand to the power supply doesn't seem to help. Things go haywire once I try to have more than 20 pixels show yellow or white. I can get 50 pixels to show red, or green or blue and I can get 20 or less to show any color. So that's why I thought it was a power issue. I think I'm hooking everything up correctly based on the power injection info I found where it said that I should take the v+ and ground lines at the end and hook up them to the v+ and ground power on the power supply, but that doesn't help. I also thought the problem might be the stand alone dmx decoder device I use for testing single strands, so I hooked it up to an AlphaPix 16 and have the same results. Here is a link to the short video that demonstrates the problem.

http://vgehts.com/5vpixel.mp4

Curiously I can select the yellow pink test on the AlphaPix and it doesn't cause a problem.

Any help in helping me understand what the problem might be, is appreciated. Thanks.
Rick

IMG 20151122 195013

7 Replies
Posts: 167
(@bigbenamerika)
Estimable Member
Joined: 13 years ago

Did you connect all the ground wires if you are using different PS?
I had that Problem at the beginning when I builded my Megatree. First the Pixel flashed, but after I connected all the ground wires... flashing was gone 🙂


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Draw a diagram showing your connections include the power supplies, pixels controller and injection points

Sent from my LG-H811 using Tapatalk


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Can you try an identical string on the same output? Also can you measure the voltage at the beginning of the string and at the end?


Reply
Posts: 4
Topic starter
(@vgehts)
Active Member
Joined: 12 years ago

It turns out that the power supply was the culprit. I bought a second one (different make) after I was getting some strange readings from my volt meter. The problem went away with the 2nd unit.


Reply
Page 1 / 2
Share: