Help with E681 web ...
 
Notifications
Clear all

Help with E681 web adress

4 Posts
3 Users
0 Reactions
1,690 Views
Posts: 74
Topic starter
(@cscool36)
Estimable Member
Joined: 16 years ago
[#39157]

Hi All,

I am having lots of trouble with getting the red status and green leds on to access the web page.
I have checked all the solder joints and re-solder some. Updated the propreller chip to V4.033.
I can access the web on my work bench but when I unplug it and take it out to my display and plug in the pixels the red and green leds will no come on and no access to web page or any lights on.
I have updated the E1.31 to the wiz net 820io.
Any Ideas????
Thanks
Colin

E681 E1.31

3 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Your picture shows you are powering up your E681 using the external power port on the top - correct? And the pixels are powered from a different supply on the large connectors on the bottom? Perhaps show all the connections. On the surface it sounds like you're drawing too much power from the source and causing it to drop too far below the operating voltage. Is there a reason you are using the non-pixel power port for powering the controller? It's OK to do - just wondering why and not using the pixel power instead.


Reply
Posts: 74
Topic starter
(@cscool36)
Estimable Member
Joined: 16 years ago

I am only using non pixel power on the bench.
At this stage when I have the e681 out in my display I will be running off pixel power 5v ws2801 pixels.
This will be the third year I have run with the current setup. Its work for the last 2 year with little problems.
My be a problem with the cat 5 cable? or the switch?.


Reply
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

i had this problem with exact same symptoms. in my case it turned out to be the ethernet cable. i ended up installing new rj45 connectors on both ends of the cable.
for testing, go setup your box in the display and temporarily try it with a different brand new ethernet cable. hopefully you have a laptop you can bring out to the box and use a small eth cable for test.


Reply
Share: