Pixel String Window...
 
Notifications
Clear all

Pixel String Window Outline and Backfeeding?

2 Posts
2 Users
0 Reactions
1,126 Views
Posts: 2
Topic starter
(@meldog312)
Active Member
Joined: 14 years ago
[#39151]

Getting my first RGB display together and tonight I am getting my window outline ws2812b strings soldered up.

Question is, in one set of windows I have 172 pixels in each window. On full white the pixels are a tad yellowish at the end, should I inject midway through the window? Or can these be back-fed, so that I can keep both power points at the same spot? Strings are 46 pixels bottom to top and 40 pixels side to side

Other 2 windows are 59 pixels high and 40 pixels wide making those two 198 pixels each one.


1 Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Back feed is fine. But if you're using two separate power supplies, you should sever the v+ line somewhere in the middle of the string.
But you can try backfeeding it from the same supply if they start and end at the same spot anyhow. It's most likely the strip itself that's causing the drop. So feeding it from both ends with the same supply will likely clear up the issue.

--Jon Chuchla--

Sent from my iPhone using Tapatalk


Reply
Share: