DIGWDF 675 Troubles...
 
Notifications
Clear all

DIGWDF 675 Troubleshooting

23 Posts
5 Users
0 Reactions
7,661 Views
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

That doesn't sound right, one way or another you need to connect the ground pin on the PIC12F675 board.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

The input connector on the 675 is the same pinout as a normal SSR: +5v needs to be pin1. GND is pins 2-4-6-8 and you use the jumper to select whether to use 2-4-6 or 8 to complete the circuit and power the 12F675 chip. The 675 controller does not use pins 3-5-7 at all.


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago
dirknerkle wrote:The input connector on the 675 is the same pinout as a normal SSR: +5v needs to be pin1. GND is pins 2-4-6-8 and you use the jumper to select whether to use 2-4-6 or 8 to complete the circuit and power the 12F675 chip. The 675 controller does not use pins 3-5-7 at all.

Correct. As I stated, pin1 is power, and I'm using pin 2 for channel 1 with the jumper set for channel 1. You've now verified for me that I do not need to connect pin 7 to ground for this to work, so it's NOT my cable.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

One thing that you might try, then, is to take the controller out of the mix. Just apply power and ground to the DIGWDF-675 board (perhaps using pin 7 on the RJ45).

Edit - never mind, it appears that you've already done that.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

Anyway, I'd still suggest double-checking everything to do with the reset pin.


Reply
Page 3 / 5
Share: