DIGWDF 675 Troubles...
 
Notifications
Clear all

DIGWDF 675 Troubleshooting

23 Posts
5 Users
0 Reactions
7,660 Views
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Tyler beat me to it -- that doesn't look right to me, either. Remember, pin-1 from the 675's output goes to pin-1 of the SSR.


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago

I'll try re-doing that tonight after work. I had a sinking feeling that was the problem which is why I took the picture and posted it. I'll let you all know how it goes. Thanks for the help!


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago

Well, 1 of two problems solved... After flipping the Cat-5 wire orientation 180° it works when I run it from the PicKit and Chip Clip. I just need to figure out the deal w/ my DCSSR. It seems I get the voltage I expect on pins 1/8 of the 675, but it doesn't run properly when going through the SR32->DCSSR->675->Dirkcheap. It might have to do with the fact that I'm running the DCSSR from one of these: http://www.newegg.com/Product/Product.aspx?Item=9SIA07R0872258

If I can't figure that out from some reading I'll post in another forum.

Thanks for the help everybody!

Edit:
I think I figured out the other problem... per http://www.doityourselfchristmas.com/wiki/index.php?title=DCSSR_Version_2.4 I think I need to pull the little 7805 from the board and jumper the outer pins:

dcssr version 2.4 wiki wrote:
If you want to drive 5.0V DC loads, you should omit the Voltage regulator and solder in a jumper between the two outer pins where the voltage regulator would go. You must use a well regulated DC voltage supply attached to the DC In power terminals.

Reply
Page 5 / 5
Share: