DIGWDF 675 Troubles...
 
Notifications
Clear all

DIGWDF 675 Troubleshooting

23 Posts
5 Users
0 Reactions
7,662 Views
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
Materdaddy wrote:I have been testing using a SR32 to a DCSSR and my multimeter shows 4.92V on pins 1/8 of the 675. The power supply I'm giving the DC SSR is rated at 500mA so it should be plenty.

Agreed. You used 470ohm resistors between the 12F675 and the 2N2222A transistors? If all those parts are good, perhaps the firmware is not turning on the pins properly?


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago

Ok, I tried taking the PIC itself out and jumping pins 1 with pins 2, 3, 6, and 7 for output and no channels appear to be working. Do I have blown/bad 2N2222s even though I never actually ran this thing? I have the outputs soldered directly to inputs on a DirkCheap SSR without RJ45s, I just soldered CAT-5 straight across:


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Not 100% familiar with the 675 - do you have the FW set for NOT sinking on the PIC? It must source to turn on the transistors - basically make sure you have 5v at the PIC output when "ON" and 0v (or near) when "OFF".


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago
budude wrote:Not 100% familiar with the 675 - do you have the FW set for NOT sinking on the PIC? It must source to turn on the transistors - basically make sure you have 5v at the PIC output when "ON" and 0v (or near) when "OFF".

Yup, it's set to drive (not sink) the transistors... per Dirk's macros:


#define	Led1	GPIO,5		; output

Led1_ON MACRO
  bsf Led1
  nop
  ENDM

Led1_OFF MACRO
  bcf Led1
  nop
  ENDM

Thanks for the idea though.


Reply
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

Looking at your picture in post 17. It looks to me like the cat-5 cable is reversed from the 675 to the Dirk cheap. The way they are laying in the picture the boards are oriented 180 from each other. It seams to me the cable should also be rotated 180 degrees and it does not appear to.

Tyler


Reply
Page 4 / 5
Share: