I have been testing using a SR32 to a DCSSR and my multimeter shows 4.92V on pins 1/8 of the 675. The power supply I'm giving the DC SSR is rated at 500mA so it should be plenty.
dirknerkle wrote:You have any of the jumpers set? Those are what connect the PIC to the INPUT, whether the pic is getting power from channels 1, 2, 3 or 4.
Yes. I have a jumper set. I have been reading voltage from the actual pins on the PIC to eliminate guesses like that. Also because I was making sure I had the correct jumper set.
Did you check the reset settings? Pin 4 of the PIC could be either an ordinary input pin or a reset pin, depending on how you have the firmware configured. If your firmware has that pin configured for reset and the pin is left floating (or grounded) on Dirk's design, you would probably get the results that you described. Just a random thought...
I'll double check, but unfortunately I doubt that's the cause since Dirk's firmware doesn't work for me either. I'd assume it wouldn't configure pin4 as a reset pin and exhibit the same behavior.
The only other thing I'm thinking is that I have something wrong w/ the way I've done my cabling... I have a cat-5 coming from the DC SSR to the DIGWDF675 and I've only hooked up 2 wires. Power (pin 1), and Channel 1 (pin 2) (with channel 1 jumper set on the 675 board). Do I also need ground (pin 7) hooked up for this to function properly? There's no schematic so I'm not exactly sure...
