DIGWDF 675 Troubles...
 
Notifications
Clear all

DIGWDF 675 Troubleshooting

23 Posts
5 Users
0 Reactions
7,658 Views
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago
[#21953]

There isn't much to go wrong w/ this device, but I can't seem to figure out my troubles. I wrote some assembly code to randomly turn on the outputs. This works great on my breadboard using a chip clip and 4 LEDs to test the 4 outputs, however I cannot seem to get this working in the actual DIGWDF 675 board. I get power/ground on pins 1/8, but I get nothing (or very low voltages) on the output pins and I cannot figure out why. Does anybody have any troubleshooting ideas for me?


22 Replies
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

I guess the first thing I would like to know to help with diagnosis is. Does it work when using the firmware Dirk has posted on his site?


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

What are you using to power it and how much voltage are you putting to the board? You'll want to supply at least 100ma at 5vdc. It'll run from a Ren48LSD output (upwards of 400ma per channel) but a common PIC's output isn't enough juice.


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago

No. That is one of the things I tried. I also tried running the board itself from the chip-clip instead of power coming in on a cat5. I can program it, I get no errors from the PicKit software, but I get no output. Dirk's firmware does work on my breadboard test setup.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

You have any of the jumpers set? Those are what connect the PIC to the INPUT, whether the pic is getting power from channels 1, 2, 3 or 4.


Reply
Page 1 / 5
Share: