Does your 8 channel relay board receive E1.31? I would guess its a DMX board so you would need either a controller that can receive E1.31 and has serial DMX outputs or get an E1.31 to DMX bridge. I believe there are also USB dongles that will output DMX from your PC. The setup in xLights sounded correct if you have hardware that can receive E1.31.
I don't know anything about E1.31. This is the relay I have http://www.sainsmart.com/8-channel-dc-5v-relay-module-for-arduino-pic-arm-dsp-avr-msp430-ttl-logic.html and I am controlling it with a Raspberry Pi3. If there is a different way I should have things setup please let me know.
I am out of town today, so I will try some of the other test suggested when I get home tomorrow.
Ok so it sounds like the Pi3 is your controller so it can receive E1.31.
E1.31 is a protocol used to get lighting control information across an Ethernet based network. Most likely you will not be using it at all. That relay board requires a device with 8 digital outputs to control each of the relays. If you are familiar with the Arduino, then you can hook it up to something like an Arduino Mega and turn the lights on and off (no dimming on a relay). Using the Raspberry PI 3 to drive the relay board is fine, but, what are you using to play the show? That will control what sort of software you will need on the PI.
OK, that makes a little more sense. What I am using is the relay board mentioned hooked up to a Raspberry PI3 using the GPIO's, Falcon Pi Player (FPP) on the Pi, and trying to make a show in Xlights that I can export to the FPP. Using the E1.31 setup in the Xlights program as I am not sure what else to use. I am trying to do this on a mac computer, so Xlights was the only software I could locate. Is there a better option or way to setup Xlights? Thanks for your help.
