A little stumped X...
 
Notifications
Clear all

A little stumped XLights, E682, pixels nodes

3 Posts
2 Users
0 Reactions
1,679 Views
Posts: 32
Topic starter
(@paladin)
Eminent Member
Joined: 12 years ago
[#43812]

Being relatively new to this hobby, I have a 682 controller connected to my laptop right now and will switch to FPP shortly after the big bugs are fixed.
1. In XLights ver 2016.51 recently downloaded, I am not able to do any tests from the test section. The software just sits there with the hour glass (busy) and do ees nothing, until I try to activate the window and then I get an error telling my that XLights is not responding. Is this a bug or am I just not holding my tongue correctly? I was able to get it to work in an earlier version I had.
2. I recently purchased a pixel net from Holiday Coro. My intent was to make a pixel display board from it, words, faces, etc. I have the bullet style nodes installed in the net. Only takes about 12 100 count strings. Now the technical part, can I connect all the strings together to make one large string or should I break it up into small 5 string pieces to accommodate the number of pixels allowed by the software and controller. I think either way will end up using the same or nearly the same number of addresses. Breaking them up would require using more outputs.
3. Another technical question, what is the best effect in XLights to make a arch and have the lights (LED's) bounce back and forth. I've tried several different effects but don't seem to be able to make the arch bounce back and forth.
4. I knew that was one thing I was missing. In XLights using the animation only selection, and using the default 50ms timing. The time length is 30 seconds. I found where I can change the time length, but I lose my 50 ms timing marks. Moves them out drastically depending on how much time. With it set to a 3 minute show, looks likes it is making the timing at 10 second intervals. Is there a way to fix that?


2 Replies
jlowe
Posts: 952
(@jlowe)
Noble Member
Joined: 16 years ago

1. You need to provide screenshots or information on how xlights and e682 are configured. Also, are you able to run the built in tests from the 682?

2. I don't remember off-hand the maximum pixels per port in current firmware, but, you've got a couple issues. First, you cannot drive more pixels per port than the hardware allows. Second, you will run into refresh issues when running a very very long string. And third, you will need power injection at multiple points.

3. Use the Single Strand effect.

4. Go to settings, sequence settings. Click timing tab and add a new timing track.


Reply
Posts: 32
Topic starter
(@paladin)
Eminent Member
Joined: 12 years ago

1. I did get the test function to work. I guess I was standing on the wrong foot or something. Anyway, it was the way I was trying to do it. But I got it now. Thanks.
2. That helps, I'm thinking of going 5 strings a piece and call it good. Uses more outputs, but that's okay. I do have 2 682 controllers.
3. I'll give the single strand a try and see how it goes.
4. Thanks, that helped. Was able to extend the time and get the timing marks for setting the lights up.


Reply
Share: