What is the proper way to setup dumb incandescent lights that work off an 8 channel relay board in Xlights?
I am trying to setup a simple Christmas light display. I am using Xlights software on my Mac computer, FPP on a Raspberry Pi3 to control music and an 8 channel Sainsmart relay board to turn the lights on and off. I found "test.py" sample program on the internet and I am able to use it on the Pi to successfully turn each channel on and off as a test, so I know it works properly.
Problem I am having is a program I put together in Xlights does not do anything on the Pi computer. I can download it to the Pi and all, but it runs without turning any of the channels on or off. I am sure it is something in the way I setup the lights in Xlights, but I cannot figure it out.
After days of searching here and elsewhere on the internet, I give up and am asking for help. I am sure it is here somewhere but I am missing it.
So fpp test mode you can turn the lights on and not with xlights test mode or you aren't sure how to model incandescent lights in xlights? Reading you post I am not quite sure where or what you are needing help with in xlights
First you need to see if you have the FPP output software properly configured. The FPP has a test page that lets you turn individual channels on and off. Once you get that working, then you can worry about getting xlights to export to fseq which can then be copied to the FPP to be played.
Haven't tried Xlights test mode. Basically I am unsure of how to set up items or models in Xlights and have been taking educated guesses. I have setup in Xlights a network type of E131, port multicast, baud rate or E131 univ 1, num channels 8 (8 channel relay board), Xlights/ Vixen/FPP mapping Channels 1-8, enabled Yes.
For example, I have one strand of lights that go over an archway by the front door. It is set to single color white, # of arches 1, # of segments per arch 1, # of lights per segment set to 100, start channel 3, from output 1. What I want to accomplish is turning the string of lights on and off using channel 3 on my sainsmart relay board. I am assuming that this is where the problem is, but not sure how it should be.
Thank you in advance for any help.
First test using the FPP display tests. Turn channel 3 on and see if your arch comes on.
