Hey Everyone,
I got schooled this weekend in the pain of mounting pixels. I had used some of the mega tree strips and have pushed pixels in some of the boscoyo coro snowflakes. It was a pain, but it was manageable.
I purchased 3 boscoyo ABS mini trees and attempted to populate them with pixels this weekend. Pushing these pixels in ABS is very difficult and after 1 10 pixel row, had to stop due to sore fingers and cramping hands. Now, I have 300 of these to do and at my preset rate I would finish in June of 2018.
I did try to use a step bit and slightly widen the holes. Worked ok at first but using a hand drill quickly led to mistakes and now I have some holes that are too big.
I thought of using a hair dryer or heat gun to warm the ABS, but I dont want to risk damaging the plastic.
Is there a way to make this easier?
Tom
Two items are very helpful. Pixel pliers and a back up block with clearance holes to support the strip while you are pushing the pixels in. I did 2800 pixels into ABS this way.
BEER! j/k. Interesting, I did like 8 minis in no time and no fuss. Where'd you get your pixels? I have switched from Ray to domestic sources and find I have less headaches with this sort of stuff. duds/out of round connectors/bad joints.
I may try the pliers but not sure if they will be able to maintain grip with the amount of pressure I will need to apply. I will make a backer block to see if that helps. These are so tight it actually removes some of the plastic coating from the pixel when inserted and I am afraid I am going to damage wiring or the pixel itself.
Pixels were purchased from DIYLEDExpress last year and I tried some other pixels that I had purchased from holidaycoro to see if there was a difference. No difference....just as difficult.
Beer was consumed :thup2:
Here's a link to at least one place to get the pixel pliers: http://www.holidaycoro.com/Pixel-Node-Pliers-p/871.htm
