Activity
 
Notifications
Clear all
mildog
@mildog
Estimable Member
Joined: Nov 24, 2014
Topics: 25 / Replies: 154
Reply
RE: Preview Props were found outside of the preview bounds and have been moved back

Tried the select tool. Could not find the props, is there anything else I could try? I selected all the listed props individually to see if I could ...

3 years ago
Reply
3 years ago
Forum
Reply
RE: New Weave Effect

I just installed 3.10 today. Do not see the weave effect. Did it get dropped from the release?

3 years ago
Forum
Reply
Reply
RE: Modifying and existing element

Thanks Jeff, I did go back into display setup and used "add multiple" and was able to add the nodes to the end of the existing number, thus keeping th...

4 years ago
Topic
Replies: 3
Views: 1931
Reply
RE: New prop and universe additions

I was thinking that is what I would end up doing. Thank you for your feedback. If you could not get it to work with the F16V3, I dont think I would ...

4 years ago
Reply
RE: New prop and universe additions

I would like to hear if you were successful. I am in a similar situation. I swapped out the GECE bulbs on my eaves with pixabulbs. I want to pull t...

4 years ago
Reply
RE: GFCI issue

I have disconnected the outside light post from the circuit. So far no trips, show has been running great. I will troubleshoot that external light p...

7 years ago
Reply
RE: GFCI issue

I did make a discovery... I checked that "bad" outlet and discovered another line connected to it. I believe this other line runs out to an external ...

7 years ago
Topic
7 years ago
Replies: 11
Views: 11571
Reply
RE: Ray's "18 AWG" pixel wire

I happened to notice this on a another vendor's pixabulbs. I have not measured the difference in the conductors, but the pixabulb conductors have vis...

7 years ago
Reply
RE: replacing a model in an existing display.

Thank you Jeff and Jon. I figured that was the outcome and thank you for all you guys do here. Tom

7 years ago
Page 1 / 12
Share: