Mega tree cement ba...
 
Notifications
Clear all

Mega tree cement base help

23 Posts
15 Users
0 Reactions
11 K Views
Posts: 121
(@buckeyelights)
Estimable Member
Joined: 18 years ago

If you plan to guy wire the tree and I'd definitely do that, then the hole doesn't have to be very deep, an 18" sleeve is plenty. All you're doing is creating a pin connection point to secure the bottom from kicking out. Make the hole about 22"-24" deep, put some gravel 4"-6" in the bottom, so when a little water gets in the hole it doesn't create mud at the bottom. If you want you can widen the bottom of the hole bigger than the diameter of the hole, creating a bell shaped hole. foundation piers for a building will often be "bell-shaped" at the bottom; increases the pull-out resistance.

If you're using the hole as the entire support for the pole, that's a completely different scenario.

good luck!


Reply
Posts: 24
(@inknown)
Eminent Member
Joined: 17 years ago

I second the portable hole. I've used it for my mega tree the last couple years. Mine is about 23' high. Survived some pretty good storms. I do drive 8-4' sections of rebar in to the ground and My lights have paracord in them that act as guy wires. The thing is rock solid though. (I think a couple of the nor'easters this year had over 50 mph winds).


Reply
Posts: 252
Topic starter
(@vincerules)
Reputable Member
Joined: 14 years ago

Thanks everyone for all the input.

I am hoping to make the hole be able to support the entire pole, but then will also put guy wires in just as an extra measure of safety. I really don't want this pole falling down, but if it does I would like to direct which way it goes.


Reply
dariansdad
Posts: 178
(@dariansdad)
Estimable Member
Joined: 15 years ago

One thing to remember in putting a sleeve in concrete. If you ever want to move the mega tree, that sleeve will need to be used for something else or just abandoned. IMHO, a movable Base such as the Portable Hole II or the 5-way base that Christmas Light Show sells will do the trick. If you know for certain the tree will stay there then a permanent hole would be the solution

I've used all 3, I like the Portable Hole II


Reply
Posts: 70
(@timbenson)
Trusted Member
Joined: 13 years ago

I also use the Portable hole II. 16 foot tree, no guy-wires. I use 4 30 inch long 1/2 inch rebar spikes to hold it to the ground. Never had an issue in 4 years. We get 50 MPH winds here in the Midwest and it is rock solid.

Tim


Reply
Page 3 / 5
Share: