IdunBenhad wrote:Hi:
Dave, the possible reason for the low voltage, 107 vdc, out of the bridge is because you don't have a filter capacitor in the circuit.The output of the bridge is actually 120 Hz, pulsating DC. The capacitor will "fill" in the valleys, holding the voltage up.
The LEDs will act as a low capacity capacitor, but not enough to hold up the voltage.
Just for kicks, try a 200 ufd/300 volt capacitor on the output of the bridge. You can get one from an old "throw-away" camera board.
That's an excellent idea -- I had thought about it briefly, but I went for "small size" instead, and the word "capacitor" disappeared from my brain (like a lot of things these days :rolleyes: )...
Unfortunately my work is keeping me in the office today (DANG!!!) and I won't be able to play with the cap idea until I get home tonite. I'm sitting here at my desk deciding how our payroll software should handle some of these wierd, one-time "stimulus package" considerations for end-of-year electronic wage/tax reporting. Apparently, the feds believe that software companies enjoy retooling their code on an annual basis...
Hi:
Good luck on the software upgrade! If you can slip it in, I could use some "stimulus" also, so maybe you could put in a check or two down this way.
dirknerkle wrote:The voltage out of the full wave diode bridge is puzzling at only 107vdc.
I could wait until you try the capacitor.:D
Did you forget that diodes have a voltage drop? Typical is around .7 volts, times two (for half of the bridge) is right around what you're missing.
ErnieHorning wrote:I could wait until you try the capacitor.:DDid you forget that diodes have a voltage drop? Typical is around .7 volts, times two (for half of the bridge) is right around what you're missing.
Hi, Ernie.
Yah, I knew it would drop a bit, but with only 4 diodes in play, I thought it'd be relatively insignificant. I think the cap is probably going to be the solution...
Hi:
After thinking about this for awhile, maybe the capacitor is not necessary.
Because the output is 120 Hz pulsating DC, the eye cannot see the flicker in the LEDs. If you calculate the current limiting resistor to the LEDs using the output voltage of the bridge, then you are "working with what you got".
IF the current limiting resistors are built into the LEDs, then the higher DC voltage obtained with the capacitor would be necessary to obtain full brilliance.
The filter capacitor will have to be relatively large to handle the current of the string(s). As you add strings to the supply, the voltage will drop off as more current is being drawn.
As Dave said, the voltage drop across the diodes, .6/.7 volts , is really immaterial. Percentage wise it is very small compared to supply of 120 vac nominal.
Another thought. Remove one or more LEDs from the string, making the applied voltage across them higher, thus making the LEDs brighter.
Funsies, huh?
