I recall that the original little 8-function controller included a bridge rectifier and one cap but it was pretty small and seemed to be there for the internal microprocessor. It was quite small -- perhaps a 16v cap and no more than perhaps 10uf. That's why I more-or-less discounted its importance to anything else. The controller had precious few internal components. A joke, really. Four 1N4004 diodes, two resistors, one cap and the processor chip. It is the epitome of "cheap." Some of the solder joints looked like they tried to use a welder. Hot glue was used to secure the five output wires to the controller, although they forgot to use enough hot glue to make anything stick.
A quick design change to your rectifier boards and they would be perfect for hacking an LED string into shorter lengths.
2 diodes and a resistor at each end of the string.
Aurbo99 wrote:A quick design change to your rectifier boards and they would be perfect for hacking an LED string into shorter lengths.
2 diodes and a resistor at each end of the string.
Hey, Steve!
Thanks -- I've read Tony's directions before but to calculate the resistance values it requires using your brain. I haven't done that in years (at least according to my kids) so I went the quick-n-dirty route and just kludged-together the led_rectifier.
Besides, many of the LEDs in these cheap strings have embedded resistors and I've found that two different seemingly identical strings may not have the same number. In my next life I plan to be a quality control manager. :rolleyes:
The more and more I work with LEDs, the more and more I hate them. Who invented these infernal things anyway? It must have been the U.S. Congress or some nondescript congressional oversight committee having to do with the environment. I want to blame somebody!
Neat idea, very good if a free photoflash cap will work!
IdunBenhad wrote:Hi:
Dave, the possible reason for the low voltage, 107 vdc, out of the bridge is because you don't have a filter capacitor in the circuit.The output of the bridge is actually 120 Hz, pulsating DC. The capacitor will "fill" in the valleys, holding the voltage up.
The LEDs will act as a low capacity capacitor, but not enough to hold up the voltage.
Just for kicks, try a 200 ufd/300 volt capacitor on the output of the bridge. You can get one from an old "throw-away" camera board.
Dirknerkle
Do you know how much it will cost to get a pcb manufactor to make 400 pcbs of those you made ? 😀
C - L
