ukewarrior wrote:So.....
you are driving 25 white LEDs off 120v AC directly with this.
I understand that the diodes convert the current to DC.
What about the amount of voltage you are presenting to the LEDs? ARe you overdriving the LEDs?
No, surprizingly. Many of the LEDs have resistors built in and if anything, the LEDs are a little under-powered as they're not as bright as they were originally. The voltage out of the full wave diode bridge is puzzling at only 107vdc. I'm sure the LEDs are not getting "cooked."
Can you please post one more picture?
The trace/solder side of the completed and wired circuit board?
dirknerkle wrote:No, surprizingly. Many of the LEDs have resistors built in and if anything, the LEDs are a little under-powered as they're not as bright as they were originally. The voltage out of the full wave diode bridge is puzzling at only 107vdc. I'm sure the LEDs are not getting "cooked."
Hi,
I have some thoughts about the different voltages applied to the strings.
We can notify these strings can be powered on 110v dc and 220 dcv too, rear the embedded (non waterproof) controller.
The same controller is provided for different voltages with same components.
So i have a doubt on different production for 110v and 220v, but the same strings accepts both voltages.
Makes non sense, but this request an investigation about the resistors who are distributed on each string...
Will be interesting to have the values of these resistors for the 4 channels and for the different colors (RGBW).
I'll need to investigate that, from my side for 220v...
Will be interesting if some one can get the values for 110v too
Today, the conclusion i have : All colors seems to be enough brigtness, when we use the strings for a tree, excepts the red who is too dark comparing to the R/G/W strings... So difficult to build a megatree with same intensity for the different colors.
May be replacing some resistors values can manage this PB.
Some ideas?
Cheers, Henri...
ukewarrior wrote:Can you please post one more picture?
The trace/solder side of the completed and wired circuit board?
The first photo in post #16 (below) shows the circuit boards with the toner still on them. The AC side is the end with the longer, parallel traces. The DC end is the one with a single long trace and a short trace the curves around the mounting hole. When I etch multiple boards that I plan to solder later, I leave the toner on the copper to keep it from oxidizing. Then just before soldering, I remove the toner and find a clean copper surface to use.
Hi:
Dave, the possible reason for the low voltage, 107 vdc, out of the bridge is because you don't have a filter capacitor in the circuit.
The output of the bridge is actually 120 Hz, pulsating DC. The capacitor will "fill" in the valleys, holding the voltage up.
The LEDs will act as a low capacity capacitor, but not enough to hold up the voltage.
Just for kicks, try a 200 ufd/300 volt capacitor on the output of the bridge. You can get one from an old "throw-away" camera board.
