Re: How do I remove 8 function controller from LED string?
Terry,
Is this picture simpler. Add the bridges underneath as per Tims picture
Craig.
Re: How do I remove 8 function controller from LED string?
That is much better. Thanks very much. I will give it a go tomorrow and let you know how it goes.
Thankyou all, Terry
Re: How do I remove 8 function controller from LED string?
That's an angle I didn't think of - modify the controller. Certainly keep it all together, great idea guys.
Here's my quick and dirty version . . . I took pictures because I'm lousy at explanation, should have just done that to start with! Hope it's of some help.
Also, sorry I wasn't paying attention - I thought you had the exact same lights as me. If I had have paid attention, I would have realised you have white ones. I got the 4 colour (red, blue, orange and green) ones. Sorry if I confused you talking about colours!
Re: How do I remove 8 function controller from LED string?
Hi tp
Like you said in the previous post - you seem to have removed the rectifier as well. (Yep - it is hiding on the board). This may not be such a good idea - for a couple of reasons.
- you're not getting the best power outcome (and frankly, who doesn't need more power/brightness!). When you're feeding the leds with AC power , half the time the Led will not be connected with the right polarity - so there will be no current for at least half the time. This cycles pretty quickly ( that 50Hz cycle) - so you'd probably only notice it as a flicker if at all. DC (rectified)- should provide more brightness though because the led is on all the time.
- also many leds I have known personally don't really like much reverse voltage across them. This might not be a problem if you have several in series but if it was only 1 led I think -24v might produce the magic smoke. So in general its better to keep them supplied with DC and limit the current with those resistors.
Tim
Re: How do I remove 8 function controller from LED string?
Thanks for that Tim, that's great to know, never had it explained to me. I had noticed a slight flicker, but hadn't connected the dots. Makes it ultra confusing when they work both ways, even if it's not for the long term!
Kinda a little bit off topic, but it is about LEDs :grin:. It's AC from the wall, it's DC from a Grinch, or any board for that matter - is that right? In that case I won't need a rectifier to drive LEDs directly from a Grinch?
I'm glad mr collingwood asked this question.

