Re: How do I remove 8 function controller from LED string?
When completely removing the led string from the controller and wiring directly to the SSROZ this is the way I do it using a small 1A bridge rectifier.
It works for me.
Craig.
Re: How do I remove 8 function controller from LED string?
I did as suggested by TimW and Prof and it worked like a charm. Of course, I knew it would. I love this forum. I would be sitting in a corner pulling my hair out if it weren't for you guys and gals.
I just wish I didn't have a work function on this weekend so I could attend the Melb Mini. I could have learned a lot and watched the mighty Pies beat the Saints at the G.
Oh well, maybe next year.
Thanks again to all, Terry
Re: How do I remove 8 function controller from LED string?
piesrule58 wrote: and watched the mighty Pies beat the Saints at the G.
doesnt look too good at the end of the 3rd quarter.. will see what the last quarter brings.. go the pies!!
Oh well, maybe next year.
Sorry to drag this up again guys
I have been following this discussion for a while. Last year I purchased some long strings of LED's from k'mart. These are something like 500 LED string and multi colored and multi function. I wanted to mod these to be driven by an olsen 595 and ssroz to control the colors as channels with vixen. I am using the original transformer that came with the set. Details are 240 volt in 24 volt out. 880mA 16.3VA.
The issue I have is that I have pulled the controller apart and the board has no resistors where previous boards on this thread have. Is it that the amount of LEDs on this string negate the need for these or is it something in the tranny that eliminates the need (or am I just not seeing something)?
While i'm at it, I want to be able to cut up one of these strings into short sections for a part of my display. will there be any issues with using the same tranny and just running it to all the sections and also will this mean that I need to add the resistor as previously stated in this thread?
Josh.

