Re: How do I remove 8 function controller from LED string?
Ok, picture helps no end..
This is defintinly a four channel devices. The four resistors together i can't quite make out the colours.. Is it yellow - brown - black - gold ??
On the small black three legged devices, is there any writing?
I'm picking they are a small FET. The controller IC, is that thing in the middle.. The rest of its just a power supply.. ( rectifying diodes and a cap ).
Re: How do I remove 8 function controller from LED string?
Here's the tracks that are switched by the FET/SCR.
My first Idea is to bridge the tracks shown in Red
This will definitely void the warranty. but it looks like this will take out the controller bit.
(usual disclaimers - its up to you I take no responsibility etc!!)
Someone with more knowledge then me might want to comment on any potential side effects of this on the controller itself. Maybe if you cut the tracks to the gate of the Fet/SCR to be sure. MPH or others - advice?
Tim
Re: How do I remove 8 function controller from LED string?
prof wrote:Terry,Do you want to trash to board or be able to reinstate it as a controller later on. It would also be easier if you used 1 set of lights per oz ssr board that way you could re usethe plugpack.
Craig.
If I need to trash the board I will. Hopefully TimW's idea will work. I have a large 24v transformer (25A) so I will not be using the plugpack that came with it.
Re: How do I remove 8 function controller from LED string?
Try this if you dont mind unsoldering the components. You can keep all the connections to the LEDs intact and reuse the plugpack and the original housing the board came in.
Re: How do I remove 8 function controller from LED string?
prof wrote:Try this if you dont mind unsoldering the components. You can keep all the connections to the LEDs intact and reuse the plugpack and the original housing the board came in.
Sorry prof, but I don't understand. I want the whole set to be run on 1 channel and I won't be using the plugpack (I will have a bunch of 24v sets running off one large transformer) Like I said, I am not very bright when it comes to electricity so I need simple instructions. Sorry for being a pain.
Thanks, Terry


