Notifications
Clear all

Usb

12 Posts
7 Users
0 Reactions
4,951 Views
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

So.. the question is really... "what's a decent Usb2Dmx dongle, that's supported by Vixen?"

Versus - "can we create a usb interface for the Renards?"

I can't give a definitive answer on the first. There are several supported by Vixen, most of which are based on an FTDI (hope I got that acronym right) usb to serial adapter. This adapter has the ability to drive the serial port at the required 250K baud rate, as well as providing the necessary start/stop bits. In the end the PC has to stream to the device, and it in turn streams out the DMX.

I'm actively trying to create a PIC based usb2dmx device (got the usb packets flowing from Vixen/PC last night.. but still dropping some packets (more work to do)). When completed, I hope it will be an easy "home etch"
board, though to make the size requirements I'm targetting, I may have to go double sided.


Reply
Posts: 597
(@entropy)
Honorable Member
Joined: 19 years ago
keebler wrote:are there any plans or workings to incorporate a USB dongle to run with Vixen?

what i would like to do is use USB port(s) to run my display. is this possible?

USB dongle for what protocol?

As stated before, USB-to-Renard is pretty well covered by almost any USB-to-serial converter and an RS485 level converter (you can get these bundled together).

DMX is also doable with a USB-to-serial + RS485 approach, but DMX is much more timing sensitive than Renard IIRC.

However, there is already an open source/open hardware "buffered" USB->DMX design that is intended to be compatible with the Enttec Pro dongles (which Vixen supports). It was designed by RPM, there was a groupbuy last year, and based on the interest, there is most likely going to be another groupbuy this year.


Reply
Page 2 / 2
Share: