Hey everyone,
second season with my light setup and I'm perplexed at an issue that I discovered recently. I'm running a Pi model 4 through wifi controlling 2 Falcon F16v4's with an ethernet cable. I ran it last halloween, Christmas, and this past July 4th with no issues.
I went to setup my halloween show last week and realized I couldn't login to FPP. I restarted the Pi and the falcons with no luck. I noticed that my Pi wasn't putting out any ethernet lights or getting an IP address. I did some troubleshooting, and finally put my SD card in an older Pi model 2. I connected this to my router directly and was able to get an IP address, ethernet lights, and login to FPP directly.
I thought it was a bad Pi, so I got a new one and reinstalled FPP v8. I tried to login to the FPP network (as well as the default 192.168.8.1 address) after installation to set it up and the network never showed up. Thought maybe a bad card, so I reinstalled FPP on a new card, and still nothing. I can't even hard wire it, because I get no ethernet lights or IP address.
I have no idea what the problem is. None of my network settings have changed since the summer when I ran my show without issue. I appreciate any input or guidance anyone has.
Thanks!
Alex
For your new sdcard, you will need to use wired to configure as it wouldn't know how to connect to your wireless. If you get no activity lights lighting up on your switch, likely have a bad cable and small chance you have a bad Ethernet port on the Pi. Second suggestion is to try an old version of FPP. 7.5 was pretty decent with the updates. Try that. Third, you can add speaker to the Pi and hear the boot up IP. Fourth, you can attach a keyboard and monitor start messing around command line but at that point definitely something else is going on.
Finally, before you go much further, visit the xLights Zoom room or the ACL chat room, raise your hand and see if anyone has some direct help.
Thank you very much, I'll give that a shot! Just to clarify though, with the Pi version 4 with built in wireless receiver, isn't part of the FPP install after you insert the SD card, to connect to the FPP network and configure the settings through its own generated SSID?
I think that SSID is not enabled until you use the wired login to check that box.
Hey guys,
so I think I found the problem. I noticed the green activity light next to the power light was very faint and barely visible. I swapped power supply's and voila! I think I had a bad power supply that wasn't providing enough voltage.
Once I swapped power, I was able to find the FPP network and login for the initial setup. Thanks for all the suggestions!
