FPP and Remote Proj...
 
Notifications
Clear all

FPP and Remote Projector control

7 Posts
3 Users
0 Reactions
2,908 Views
TomsLEDs
Posts: 444
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago
[#58292]

From what I read so far, for FPP to control a projector it would normally be through the serial port via a PI Power on script. My Epson has a network app that I can log into and control it, but I don't think I could get the Pi to do that. It does have a couple options like auto on when powered up & it may have a communication monitor for the HDMI port and I think this script below works like that:

#!/bin/sh
###########################################################
# Start-HDMI.sh - Turn on HDMI output #
###########################################################

/usr/bin/tvservice -p

Would I be better off just using auto start option with a programed wall power timer and then letting it power itself off when there is no activity (like 15 minutes) or pursue the script on/off option?


6 Replies
Posts: 89
(@rreese)
Estimable Member
Joined: 5 years ago

There is a plugin for FPP called Projector Control
Install that and it will make life easier. There are a number of people that us it.


Reply
TomsLEDs
Posts: 444
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago

Thanks. Got the plug enabled for Epson 500. Don't see what I do after that or where to enter the IP address.

Configuration:

  • Select your Projector
  • The Projector Plugin will load the default settings for the projector chosen
  • For network based projectors, you will have to enter the IP address
  • Depending on the Projector selected, you might have to enter a password or Port
  • The Projector Control plug in now supports using FPP Commands

Reply
Posts: 89
(@rreese)
Estimable Member
Joined: 5 years ago

Page 205 of this PDF explains the plugin.
Also search the document for projector and you will find other information on how to use it once the plugin is configured.
https://falconchristmas.github.io/FPP_Manual.pdf


Reply
TomsLEDs
Posts: 444
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago

Thanks rreese but nothing under the Epson configurations are showing anything but serial. I tried them all. I may try other vendors to see if a PJLINK protocol will connect. I can log into the projector and control it with my pc, so logic would dictate there should be a way for Falcon to do the same.


Reply
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

Tom, you should be selecting pjlink as the projector. pjlink is not specfic to a manufacturer.

1728097090360

Reply
TomsLEDs
Posts: 444
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago

Ah HA! I will give that a try tomorrow.


Reply
Share: