XBee Wireless Modul...
 
Notifications
Clear all

XBee Wireless Modules

19 Posts
7 Users
0 Reactions
9,209 Views
Xenia
Posts: 1358
(@xenia)
Noble Member
Joined: 15 years ago

Mandane,

You mentioned an explorer board. Have you tried using the explorer as your transmit platform for the Xbee and use both of your Ren-W in receive mode on the renards?

Just a thought. It avoids the rs232/rs485 issue.

Randy


Reply
Posts: 15
(@madane)
Active Member
Joined: 19 years ago

Hi Xenia
Thanks for the reply i have not yet assembled the controller board to test with the renard WC receiver

Madane


Reply
Posts: 15
(@madane)
Active Member
Joined: 19 years ago

HI Dirknerkle

I have Purchased Hexin 485 converter as per the data sheet DB9 pin 1 = -Data Pin 2 = +Data so i have to connect -data to 1&2 of J1 in Renard WC and +data to to pin 4 of J1 in Renard WC.

Thanking you in advance
Madane


Reply
Posts: 15
(@madane)
Active Member
Joined: 19 years ago

Hi ,

Renard wireless connected with RS 485 data to Renard wireless and i am able to communicate with the other wireless after changing the configiration in XCTU funtion set as RS485 in the transmitter and the fontion set as USB adapter in the explorer i am able to comunicate with the XCTU. Changing the Xbee confiration reciver to RS485 and connecting with the other renard wireless , now i can communicate with the Renard wireless unit. I have added one led with resistor to the unit and i am able to see the blinking led as per the sequence transmitted.
Thanking you all for the infomation given to me
Madane
Now i am going to other thread for my renard48LSD controller which is problem


Reply
Page 4 / 4
Share: