I am in need of converting my ren64s to dmx. I have desgined an all-in-one solution. The Ren64, the way I have it set up is to take in the zc signal via pins 7 and 8 of the input rj45 and 5v power at U1. So I need two connections. In the design below I have tried to emulate that by injecting the zc signal through the Renard rj45 on pins 7 and 8 along with a separate 5v power connection. This required a regulated 5v supply which I tried to configure on this pcb along with a zc circuit.
This is the 1st time I have attempted something like this. I think I got my head around the 3 separate circuits, zc, 5v and control. I would ask all of you to look it over and confirm if it will work. I have attached the pcb along with the BOM in case I have picked a few incorrect components.
As always Thanks for your time.
The BOM is in excel, the pcb is in ExpressPcb as well as a bit map image for those that do not have ExpressPCB.
I still want to add some fuses on the 110v input side of the pcb and maybe on the regulated 5v side.
edit: New pcb attached below, in post #5.
Don't know how much 5v power you need but your layout doesn't really allow for a heat sink on the regulator. You may want to free up some space around it even if not using one.
In taking a closer look it appears I am going to have to take the supply for the 5v from between the secondaries of the transformer and the zc diodes and utilize another set of diodes to isolate the caps on the 5v side from smoothing out the zc signal. According to the wiki I need .5a for the ren64 using PWM firmware without the leds on the pcb.
I should be able to get a heatsink on after I move a few things around a bit.
You may want to move the 5v output away from the mounting hole area a bit or turn it 90 to go out the side - just a liittle too close to it maybe.
I re worked the pcb based on the above posts. It is attached below. One thing I am not clear on though is the gnd for the 5v output. I currently have it connected to the CT of the transformer since the + side is coming from the other 2 secondaries. Is this correct? Does the gnd need to be tied to the gnd of the DMX and REN rj45s? Again the ExpressPCB and a BMP are attached.
