Super Strip Flood C...
 
Notifications
Clear all

Super Strip Flood Controller

240 Posts
30 Users
0 Reactions
91.6 K Views
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

Phil-
Thanks for the suggestions on the LM2575. I have made a few changes to the board; it is a little wider, but I think better. Let me know if there's something I could improve on it.

- Changed the diode to an SMB package (SMA would also fit); This will let us use a 2A or 3A diode, like the B340
- Moved the diode to the same side as the inductor to get rid of the via
- Moved the caps to the pin-side of the IC to reduce the current loops
- Changed the output cap to a larger package to allow for more choices; EKZE160ELL331MHB5D is a 330uF 16V low ESR part, and would let us go to 12V out.
- The Wurth 7447709331 would fit on the same footprint, and is a 1.5A inductor if we need a bit more current.
/mike


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

So this regulator replacement is going to require an SMD oven or hot air gun to build?


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

You can solder SMD with a hand held iron.
I've done a few builds with them.
This is especially true with a small number of parts as in this regulator.

Jrd wrote:So this regulator replacement is going to require an SMD oven or hot air gun to build?

Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago
ukewarrior wrote:You can solder SMD with a hand held iron.
I've done a few builds with them.
This is especially true with a small number of parts as in this regulator.

Ok, so I guess you would solder the SMD components first and with tweezers?


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

Yes; I'd use tweezers for everything except the inductor; that's big enough for fingers to work, Then I would solder the two capacitors and connector. I changed the resistors to 0805 packages to make it a little easier to solder. If there are no more suggestions or changes, I'll send it off for fab. Please let me know if there's anything I should change first.
/mike


Reply
Page 41 / 48
Share: