Super Strip Flood C...
 
Notifications
Clear all

Super Strip Flood Controller

240 Posts
30 Users
0 Reactions
91.6 K Views
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

If it reduces the cost, I see no reason for the silkscreen since all of the surface will be covered.

n1ist wrote:Yes; I'd use tweezers for everything except the inductor; that's big enough for fingers to work, Then I would solder the two capacitors and connector. I changed the resistors to 0805 packages to make it a little easier to solder. If there are no more suggestions or changes, I'll send it off for fab. Please let me know if there's anything I should change first.
/mike

Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago

Looks great Mike!


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

Most of the cheap houses do at least topside silk for free.
/mike


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

OK, I just sent off for a panel of the regulator boards. I made two more small changes before I realized that I will keep "improving" things if I didn't send it for fab:

- Added a trace between the two pads of R2. Most of the time, we will be using fixed-output regulators; this will save having to install the 0-ohm resistor. If you do want to use an adjustable regulator, a few seconds with an exacto knife will remove it.

- Added footprints for ceramic caps at the input and output. These parts aren't needed but may help tame wierd oscillations, and don't cost anything to add.

Boards should be here in 10 days to 2 weeks. Silk on both sides was free with these guys, so I went for it.
/mike


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

Fantastic.
I can't wait to build one.

n1ist wrote:OK, I just sent off for a panel of the regulator boards. I made two more small changes before I realized that I will keep "improving" things if I didn't send it for fab:

- Added a trace between the two pads of R2. Most of the time, we will be using fixed-output regulators; this will save having to install the 0-ohm resistor. If you do want to use an adjustable regulator, a few seconds with an exacto knife will remove it.

- Added footprints for ceramic caps at the input and output. These parts aren't needed but may help tame wierd oscillations, and don't cost anything to add.

Boards should be here in 10 days to 2 weeks. Silk on both sides was free with these guys, so I went for it.
/mike


Reply
Page 42 / 48
Share: