Yes, most certainly, if you're using triacs, the POWER section that's being controlled must be A/C, or the triac won't work properly. However, the method used to trigger the triac can be DC, and that can easily be done with PWM firmware because the firmware merely turns the triac on and off for a specific period of time.
Of course, it's possible that you can run into a syncronization problem with PWM and A/C if the two aren't in sync with one another and that would likely show up as some uneven dimming in some capacity.
But in practice, it seems to work okay in most cases.
dirknerkle wrote:Yes, most certainly, if you're using triacs, the POWER section that's being controlled must be A/C, or the triac won't work properly. However, the method used to trigger the triac can be DC, and that can easily be done with PWM firmware.
Yes, I was not discussing the merits of using a DC or AC voltage to trigger the triac. I was discussing the fundamental need for a Zero Cross Signal to dim AC loads, without it, the triac will not dim as you expect it to.
Hmmm.... As I said, I think I've seen many posts where folks only use PWM for both AC and DC for both LEDs or Incans and get good results? Isn't the default code in most Coops PWM? Could be wrong - and for me personally - it doesn't matter as I plan to get to 100% DC by next year or so...
budude
As a long term user of the lm2575 couple of things to watch,
Low ESR caps should be used for best stability.
The catch diode should have a current rating higher than the Reg, 1A is borderline.
Same comment for the Inductor, 1A is borderline.
Both the chosen will work fine for lower loads of course.
It is as tough as nails and will happily work even in a breadboard but it is sensitive to good PCB layout and i'm not convinced that putting the catch diode on the rear of the board is a good idea. (in theory and based on layouts)
However if it is stable in real life then all is good.
Cheers
Aussiephil
aussiephil wrote:bududeAs a long term user of the lm2575 couple of things to watch,
Low ESR caps should be used for best stability.
The catch diode should have a current rating higher than the Reg, 1A is borderline.
Same comment for the Inductor, 1A is borderline.
Both the chosen will work fine for lower loads of course.
It is as tough as nails and will happily work even in a breadboard but it is sensitive to good PCB layout and i'm not convinced that putting the catch diode on the rear of the board is a good idea. (in theory and based on layouts)
However if it is stable in real life then all is good.Cheers
Aussiephil
Thanks for the comments Phil - always appreciated. I'll have to round the wagons with Mike to ensure we have chosen wisely. I know for the LSD components I chose, the diodes/inductors are at least 2A or more yet the current draw will be <500mA so I think I'll be good. I've breadboarded out the circuit and let it run at 600mA load for more 24 hours and it looks good so far. Thanks again!
