Simple Renard Strob...
 
Notifications
Clear all

Simple Renard Strobe Burst

124 Posts
29 Users
0 Reactions
52.3 K Views
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
robots4joey wrote:I came up with another question too:
Will these work with a converted grinch controller runnning DMX?

Thanks so much for the help!

I am not familiar with the Grinch hardware hopefully someone else can chime in..

Thanks for your interest in the SBM's


Reply
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

The Grinch is not a suitable controller to drive the strobe burst modules. The strobe burst module requires a positive voltage on the STR input to turn it on. The MBI5027 chips used as output drivers on the Grinch are sink only and cannot provide the positive signal needed.

Tyler


Reply
Posts: 221
(@robots4joey)
Reputable Member
Joined: 19 years ago
tstraub wrote:The Grinch is not a suitable controller to drive the strobe burst modules. The strobe burst module requires a positive voltage on the STR input to turn it on. The MBI5027 chips used as output drivers on the Grinch are sink only and cannot provide the positive signal needed.
Tyler

Bummer... so even with the converters for DMX, this won't work? What about doing a on-off simple SSR from the parallel port, is that a positive (non-sinking) signal?
I also have the Olsen 595's with REN-T and REN-C's I assume I can't do it with that either.


Reply
Posts: 221
(@robots4joey)
Reputable Member
Joined: 19 years ago

So I think the basic parallel port SSR will control these! Someone correct me if I'm wrong, but the old-school 8 channel SSR Direct attach was a source based switcher. So in theory, these strobe burst modules could be turned on or off with the parallel port (No Dimming). Does this sound right to everyone?

Thanks again for the help!!!


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
robots4joey wrote:So I think the basic parallel port SSR will control these! Someone correct me if I'm wrong, but the old-school 8 channel SSR Direct attach was a source based switcher. So in theory, these strobe burst modules could be turned on or off with the parallel port (No Dimming). Does this sound right to everyone?

Thanks again for the help!!!

The Strobe Modules have only been tested on the Simple Renard 8 ,Simple Renard 16, Simple Renard 24 and Simple Renard 32 and they will probably work on an REN 64 although that has not been done because I do not have one. So as for any other controller it is a shot in the dark since I have none of the ones you have mentioned to test them with.


Reply
Page 24 / 25
Share: