Simple Renard Strob...
 
Notifications
Clear all

Simple Renard Strobe Burst

124 Posts
29 Users
0 Reactions
52.2 K Views
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
dirknerkle wrote:I think that would work. That's essentially the kind of setup I plan to test. In wireless mode, using a regular XBee module will require less current than a Pro model and leave more juice for the rest of the board but even at 12ma/channel, that 96ma total is pushing the PIC16F688 pretty hard -- that's right at the very edge of what the PIC can manage... of course, you don't have to drive the units at 100% either.... I doubt you'd notice much difference between 90% and 100% in terms of brightness and that would put your current draw on the pic down into the mid-80's... a little breathing room there...

Hi Dave,

that is the total current on the +5 volt supply,,, there is only about 3 to 4 ma across the PN2222a and about 9-10ma on the 5 volt supply for each strobe module,,, so 3-4ma on each channel of the PIC and 9-10ma on each strobe module is about 12-13ma total on the +5 volts


Reply
Posts: 35
 wbe1
(@wbe1)
Eminent Member
Joined: 18 years ago

Any further info about when they will be available????????????????????????????

thanks
Wally


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
wbe1 wrote:Any further info about when they will be available????????????????????????????

thanks
Wally

There is going to be a few hundred of them ordered very soon, we had to make a small change on the PCB's, the pot was wired backwards on the first PCB's so min. and max. was reversed ...:biggrin:


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Isn't that just a silk-screen error? 🙂


Reply
Materdaddy
Posts: 2368
(@materdaddy)
Famed Member
Joined: 16 years ago
Mactayl wrote:I have added code for testing to the first post if anyone wants to give it a go, it is pretty much the same code used on the Simple Renard 16 except it is setup for LED's. 🙂

Mis-post, please delete or ignore.


Reply
Page 21 / 25
Share: