P. Short wrote:I haven't done any sort of comprehensive review of the design, but I would say that the ground plane under IC2 is in need of a careful look. In particular, the ground connection to pin 31 of IC2 is only connected to the rest of the ground through some long slivers of copper, which is not so good for emi and signal integrity. The trace on pin 1 of IC2 is similarly problematic, as it increases the size of the ground-plane interruption. I think that it would be a good idea to move as many of the traces (or as much of each trace as possible) on the ground-plane side of the board to the other side, so that there aren't all those long slots cut in the ground plane.
I see what you mean on some of the traces by IC2, are you also referring to IC6 and IC5?
tstraub wrote:Is the 18F45K22 PICkit2 flash-able? I think that's the chip that made me break down and buy a PICkit3. Just thinking about all the guys buying pickit2 clones.The board looks great as always Mac keep up the good work.
Using the PICKit2 App V2.61 and latest device file (V1.62.14) it is supported. You just don't have MPLAB support (according to Microchip website).
http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en027813
I have some questions:
1) Will this support DMX or just Renard code?
2) What voltages will the 3 channel DCSSR support
3) What will the pinouts be? From the board, it looks like you are running switching signals to 1,3,5 and power to 2? How will a 4 conductor RJ11 use pins 1,2,3 and 5?
4) What wire do you plan on using to connect to the SSR? If you go Cat5 you are wasting half the cable unless you use 1 cable for 2 DCSSR's. In that case maybe RJ11 isn't the best choice. Maybe something more like the E682 connectors. would be better and easier to splice/wire up.
RavingLunatic wrote:Using the PICKit2 App V2.61 and latest device file (V1.62.14) it is supported. You just don't have MPLAB support (according to Microchip website).http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en027813
Thanks I just upgraded my PICkit software to v2.61 and tried to flash a PIC18F45K22 with my IPC01-V1 the software gave me an unsupported device error. So I went to Piccircuit's website and did a little reading in the FAQs and I found a patch. I download and applied the patch and it works great. I can read, write, verify, it all works great. This patch may not be required with the new IPC01-V2 programmers mine is about 3-4 years old. I retract my earlier statement no compatibility issues at all go for the chip that cost less.
Tyler
Mactayl wrote:I see what you mean on some of the traces by IC2, are you also referring to IC6 and IC5?
Yes, I originally meant IC5 and IC6, as I thought that the 'IC2' label applied to the left-most PIC. And now that you mentioned it, I see that there are issues with the ground under IC2 as well.

