Notifications
Clear all
RavingLunatic
RavingLunatic
@ravinglunatic
Noble Member
Joined: Jun 1, 2007
Topics: 36 / Replies: 1466
Reply
RE: Ren SS16 issue

Really sounds like a short in the +5VDC circuitry. IF there is a short, the troubleshooting steps probably will give misleading results. I would rem...

13 years ago
Forum
Reply
RE: recent disappointing activities

buymyemu wrote:Yes please, reinstate the joke thread. (Seems to me a statement was made at the time of closure that some of the jokes were off color,...

13 years ago
Forum
Reply
RE: Need to program start address for Ren48LSD - Renard Protocol

11Bravo wrote:I tried assembling the original a few times already and got the same results. Maybe the MPASM is bad and I should reinstall the MPLAB so...

14 years ago
Forum
Reply
RE: probems with u8

U7 passes data to U8 EDIT: Wayne is quick todaySo if swap U7 with U6 now and suddenly channels 9-16 stop working then you know where the problem lie...

14 years ago
Forum
Reply
RE: probems with u8

kjjk wrote: 00.4 is both u8 14 4 and u6 14 and 4 You probably need to adjust the scale on your meter. You should be able to see something around ...

14 years ago
Forum
Reply
RE: probems with u8

Just to be clear (which maybe I wasn't): U8 pin 14 (GND) to U8 pin 1 = should be 5 VDC Compare voltage at U8 pin 14 (GND) and pin 2 to voltage at U6...

14 years ago
Forum
Reply
RE: Ren48LSD RJ45 Pins

11Bravo wrote:Instructions on Building the REN48LSD: Is the note about pin 7 on the RJ47 not being connected to anything still good? I don't know how...

14 years ago
Forum
Reply
RE: probems with u8

Ok, back to basics: Check with your multimeter/voltmeter: U8 pin 14 (GND) to U8 pin 1 = should be 5 VDC Compare voltage at U8 pin 2 & pin 4 with U6...

14 years ago
Forum
Reply
RE: probems with u8

I think maybe you are missing a small point here: If the PIC in U6 or U7 isn't working correctly then U8 won't do anything either. You definitely ne...

14 years ago
Forum
Reply
RE: anyone have a renard that they are thinking of selling(cheap)

Wayne probably still has some kits available:

14 years ago
Forum
Reply
RE: Simple Renard RGB+W no longer on DIYLEDExpress site...why?

Looks like bare boards are still available:

14 years ago
Forum
Reply
RE: New HLS_UMaRG PDF conversion process

Dennis Cherry wrote:Can the Wiki home page tree be updated to show HLS? it only shows Vixen right now under software. If you are talking about the i...

14 years ago
Reply
RE: Do we need to change the order of assembly on the SS Series?

For those members who would like the assembly instructions in a different order, I have added a doc version of the instructions to the wiki that you c...

14 years ago
Forum
Reply
RE: Problem with my SS16 (power led don't power on)

Pickup the Beginners Setup Guide starting at step 28 and you should be able to follow it to find your problems. Make sure you have a fuse installed i...

14 years ago
Forum
Reply
RE: Problem with my SS16 (power led don't power on)

The board must still get power to the left side of the board. The board uses the left side AC to create the on-board DC. Is that how you have it con...

14 years ago
Forum
Page 1 / 101
Share: