Renard Plus RGB Str...
 
Notifications
Clear all

[Closed] Renard Plus RGB Strip Controller

96 Posts
31 Users
0 Reactions
32.3 K Views
Posts: 281
(@bert-nc)
Reputable Member
Joined: 18 years ago
Mactayl wrote:Hi Folks,

We are working on a 48 channel RGB Strip Controller that will use 3 channel DC SSR's so you control 16 RGB strips per board. This is just a rough draft, this was inspired by DaveJZ. I still need to add the RenW, PIC Bypass and and see if there is any real interest in the board.

Thanks
Mac

I already have an idea that needs this controller

bert-nc


cenote
Posts: 350
(@cenote)
Reputable Member
Joined: 19 years ago

Icsp header..I'm sold 🙂


Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Member
Joined: 17 years ago

Just another quick picture of the layout,, still need to add and change a few things..

Renard Plus RGB Strip Controller view

tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

Is the 18F45K22 PICkit2 flash-able? I think that's the chip that made me break down and buy a PICkit3. Just thinking about all the guys buying pickit2 clones.

The board looks great as always Mac keep up the good work.


Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

I haven't done any sort of comprehensive review of the design, but I would say that the ground plane under IC2 is in need of a careful look. In particular, the ground connection to pin 31 of IC2 is only connected to the rest of the ground through some long slivers of copper, which is not so good for emi and signal integrity. The trace on pin 1 of IC2 is similarly problematic, as it increases the size of the ground-plane interruption. I think that it would be a good idea to move as many of the traces (or as much of each trace as possible) on the ground-plane side of the board to the other side, so that there aren't all those long slots cut in the ground plane.


Page 2 / 20
Share: