Renard Based Wirele...
 
Notifications
Clear all

Renard Based Wireless Servo PCB

12 Posts
5 Users
0 Reactions
4,308 Views
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

I just looked at the board; there are a few things you may want to look at:

- I'd throw a big cap across the servo power connector; servos can draw a bit of current.
- When you have JP3 in the 5v position, there's no bulk cap on the 5v rail. On my DMX-servo project over at DLA, I had to use 470uF to keep the micro from resetting with big servos.
- Some versions of the 7805 get unstable without 100n or so of ceramic caps from Vin to gnd and Vout to gnd right at the pins.
- The ground pins on all the servos except the left one aren't connected to ground since JP1 breaks the ground pour. Rotating the servo connectors and servo power 180 degrees will let you route the traces better on a single-sided board
- The ground pour is very swiss-cheesed (a common issue with a single-sided layout). Routing the trace feeding XBEEp3 on the other side of the connector will let the ground of the XBEE, the 3.3v regulator, and the bypass cap be nice and solid. Rotating the PIC's bypass cap would let you tie it directly to pins 1 and 14. Still a bit messy back to the regulator, though.
- The mounting holes don't line up with each other

/mike


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Mike makes some really good points. On routing traces beneath the XBee, the original goal (per the Digi people) is not to put power or signal-related traces beneath the XBee radio for fear of changing its transmitting antenna properties, but in this case, since it's a receiving unit only and is not transmitting, changing the routing to go along the header pins probably won't harm reception at all and is a good idea.


Reply
Page 2 / 2
Share: