DMX works by passing a full packet/payload (aka Universe) of data along, and each device will pick the values for it's matching channel number out of the stream. This has the disadvantage that you need to manually set the channel address of each device. This has the advantage that multiple devices can respond to the same addresses if you want.
Are there any DIY controllers on the site that operate that way or are they all Renard style DMX?
If so - what is the bus rate most operate at? Are there any at 250Kbps? Is there a need or a want for that level of performance?
Thanks.
Joe
For Renard - simple enough to "fix" - just jumper the in/out connector D+/D- lines and you have THRU to all downline controllers. The Renard/DMX code runs at 250Kbps as well - it's as DMX-ey as anything else...
There are a few other controllers - most from RPM that act as standard DMX controllers but they aren't very common - take a look at the Wiki.
Besides the rich Renard family of controllers, over at DLA there is the Lynx Express (which does light curves, BTW), Lynx Freestyle, MR16 and DMX SSR.
There's the LOR (Light-o-Rama) which can speak DMX; it's on the periphery of the DIY field but many people arrive here with them already.
There's the TigerDMX and AVD's stuff at ACL down under.
Then on the source side, there's the ECG-DR4 e1.31 to DMX, and one from SanDevices (at least on the wiki). And lots of dongles.
I'm sure there are others which don't come to mind.
Not DIY hardware, but Ray Wu has some cheap DMX controllers which are used by some in the field (they can still DIY for everything else).
There's some DIY DMX to servo for physical animation.
And the professional equipment for DJs and theater (eg: lasers), which some people cross over into for special effects.
And pretty much all the sequencer software speaks the protocol. (There's an additional layer of interface needed tho - either a dongle or e1.31).
So DMX is probably the most common lingua franca in the christmas light animation world. The e1.31 encapsulation of multi-universe DMX is gaining ground to supplement that.
Of course, this wouldn't matter to somebody who was just starting out fresh and had no interest in interconnecting. But people have a lot of existing hardware, and it's nice to be able to daisy chain DMX old and new. Or there might be a DCSSR controller you want to mix and match with, even if one is building their own AC controller.
The above should be protocol and RS485 electrical compatible.
Note that there are some differences in cabling. The pro world uses XLR 3 (low end) or the official XLR5 (high end); while most of the DIY crowd uses RJ45 and cat5 - but this only needs a passive adapter cable, as they are electrically and protocol compatible.
Alas - there IS some unfortunate discrepancy in regard to which pins to use on the RJ45 version (again, needing only an adapter to fix, if it comes up), in particular some swapping of pins 4 and 5. I would tend to go with the Renard SS series (5 is DMX +) as that's the most common. I think there may now be an official DMX standard for RJ45 as well (to supplement the XLR-5), but I haven't yet researched it.
http://www.doityourselfchristmas.com/wiki/index.php?title=DMX
The official standard for DMX over RJ45s is pins 1+2 for data and 7+8 for ground. I believe all of the DIY DMX stuff other than Renard use that pinout.
