MiniRen8/4
 
Notifications
Clear all

MiniRen8/4

130 Posts
29 Users
0 Reactions
50.4 K Views
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
dale wrote:I was thinging of more just a remote controling a wireless relay

You should dig into XBee a bit -- it has 8 digital lines that can be controlled, too so you theoretically could control 8 different circuits wirelessly. We're not using them for Ren-W since we're using the radio only for its serial communication capability, but it's an amazing little gizmo. Has it's own microprocessor, PWM, 8 digital lines, and more, and it has space for executing your own code, too. They packed a lot of stuff into that little guy!


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

You may want to remove the ground plane and traces under the opto. It doesn't look like there's enough separation there; all it takes is a little conductive schmutz, and you have 110v on your PC's ground through the serial port...
/mike


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
n1ist wrote:You may want to remove the ground plane and traces under the opto. It doesn't look like there's enough separation there; all it takes is a little conductive schmutz, and you have 110v on your PC's ground through the serial port...
/mike

That's a good idea, thanks. shortening the ground plane is a piece of cake. The trace supplies +5v power to the MOC3023s and I'll have to see if there's another way of getting power to them without having to go to a 2-sided board or putting some top-wires on it. But an excellent safety point well taken, thanks!

"Conductive schmutz." Good term. I like it. Good on the onomatopoeia quotient!


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

What about running the +5 trace between the pins on the jumper header? It may be a bit close for home-etch, but it looks like you are already running a trace between the pins on the PIC. Also, the ground plane looks quite chopped up. If possible, I would at least try to improve the PIC's grounding and have its bypass cap's ground have a better path to the PIC ground. Maybe run the pin3 trace between the two legs of the bypass cap?
/mike


Reply
Mactayl
Posts: 2491
Guest
(@mactayl)
Member
Joined: 17 years ago
dirknerkle wrote:That's a good idea, thanks. shortening the ground plane is a piece of cake. The trace supplies +5v power to the MOC3023s and I'll have to see if there's another way of getting power to them without having to go to a 2-sided board or putting some top-wires on it. But an excellent safety point well taken, thanks!

"Conductive schmutz." Good term. I like it. Good on the onomatopoeia quotient!

You could also make the 110v traces that go to the opto's much smaller they only need to carry several ma. of current, that would also reduce the Conductive schmutz factor. 😎


Reply
Page 2 / 26
Share: