MiniRen8/4
 
Notifications
Clear all

MiniRen8/4

130 Posts
29 Users
0 Reactions
50.4 K Views
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
[#14211]

Well, I'm at it again. After a successful 2010 season I'm back on the development bench working on a smaller and more compact Renard with on-board SSRs. My goal is to make a wireless 4-channel SSR which will fit inside an outlet box. Why, you ask? Well, I have nine 4-color window frames on my house that currently have SSRs and were controlled this year by wireless Ren64s. I've got a whole bunch of extra Xbee radios and if I can pull this off, next year all I'll have to do is run A/C power to the outlet boxes attached to the frames. I can use start_address firmware and put the control exactly where I want it to be.

I've already started... here's my progress so far: the MiniRen8/4. It's an 8-channel renard with four on-board SSRs. The board measures 3.5 x 2.25 x 1" tall, so I've succeeded in making it fit in an outlet box. Since there are only 4 SSRs, you assign the 4 Renard channels you want to the ssrs by short patch cables that plug into the dual-row of header pins between the 16F688 and the row of MOC3023's. So the combination of the PIC's start_address (which has to be on an 8-channel boundary) and the ability to assign the channels I need to the SSRs will provide the flexibility I need to control each frame. All that's left is to figure out how I'll incorporate the XBee into the mix, and provide 9-12vac power to the board.

Here are a couple photos of the finished and working prototype and the home-etchable board. This project has taught me one importantthing about using a ground plane on a compact, home-etched board: without a solder mask, it requires verrrrrrry careful soldering and a strong magnifying glass to find solder bridges. I have always appreciated solder masks but never quite as much as I do now!!! The photos show the board still with toner/paper after etching, the cleaned and drilled copper and the board held up to a backlight to check the ground plane.

So that's all I've got for now... I'll keep forging ahead on this project which now seems like the solution is well in reach -- and I'll be able to use all those extra XBees I ordered during the development of the Ren-W! 😎


129 Replies
Posts: 99
 dale
(@dale)
Estimable Member
Joined: 17 years ago

with using the Xbee hardware is there any way you can tie that to a transmitter like a hand held remote. I have a few ewlays that are wireless that ai use on halloween props


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
dale wrote:with using the Xbee hardware is there any way you can tie that to a transmitter like a hand held remote. I have a few ewlays that are wireless that ai use on halloween props

This will most certainly be linked up with an XBee to make it wireless, but it would still need 120vac to power lights through the SSR. I'm not aware of too many hand-held remotes running Vixen with the Renard protocol... which is what this is intended to use.


Reply
Posts: 2128
(@livermore-dad)
Famed Member
Joined: 16 years ago

Like it, love the idea of a smaller 4 channel board.


Reply
Posts: 99
 dale
(@dale)
Estimable Member
Joined: 17 years ago

I was thinging of more just a remote controling a wireless relay


Reply
Page 1 / 26
Share: