Power Line and Ethe...
 
Notifications
Clear all

Power Line and Ethernet

7 Posts
6 Users
0 Reactions
3,286 Views
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
[#14172]

Does anyone have any experience with Powerline networking and the throughput one can achieve using it? It's touted as a good solution for home networking (put your computer anywhere), and Netgear has an adapter that supposedly can deliver 85mbps.

I'm thinking that using such a device could work with an ethernet to serial (232 or 485) converter at the receiving end and all one would need is a single 120vac power connection to the display -- which would then carry both control signal and power.

I'm generally one to more-or-less jump into the water without looking to see how deep it is, but just this once (:lol:) I thought I'd sample the world for first-hand info.


6 Replies
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

It would also be interesting to know how well they work with all of the electrical noise that the many of the controller designs put back into the power lines.


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Would the PIC/logic section inject noise or is it more the optos/triacs? Or the ZC circuit?


Reply
Posts: 597
(@entropy)
Honorable Member
Joined: 19 years ago

There are going to be a lot of transients from the triacs switching on/off. Dimmers have always been kind of notorious for EMI issues.


Reply
Posts: 1041
(@christmas-light)
Noble Member
Joined: 18 years ago
dirknerkle wrote:Does anyone have any experience with Powerline networking and the throughput one can achieve using it? It's touted as a good solution for home networking (put your computer anywhere), and Netgear has an adapter that supposedly can deliver 85mbps.

I'm thinking that using such a device could work with an ethernet to serial (232 or 485) converter at the receiving end and all one would need is a single 120vac power connection to the display -- which would then carry both control signal and power.

I'm generally one to more-or-less jump into the water without looking to see how deep it is, but just this once (:lol:) I thought I'd sample the world for first-hand info.

Well I am using Linksys PowerLine PLE200 Right now as "home" network, and they can handle 100 Mbit/s beteween each pc, and I must say that they work great, but not as great as my cisco fiber network switch 😀 😆


Reply
Page 1 / 2
Share: