Just for grins, I put the ExpressPCB file for the MiniRen8XBLSD board in the COPPER section of the file library. And no, I do not have plans to create a board buy, or a bom buy, or anything of the sort. I had a few boards made for my own use, and that's where I left it... It is a completely home-etchable board, as are all the boards I design.
The part values are actually listed on the board itself -- I thought it was easier to do that than use a reference number...
Thank you Dirk.
Dirk, Why did you choose the transformer you did instead of the 838-3FS-312 in the RenSS BOM?
Oh one other thing, on the WiRen all in one could the WiRen Module be moved to the far right in case an XBee with an SMA antenna was desired? Looking at the image again I guess there is enough space open on the power tie card and if the XBee was on the far right then the enclosure may be an issue for an external antenna.
Jrd wrote:Dirk, Why did you choose the transformer you did instead of the 838-3FS-312 in the RenSS BOM?
It was a transformer I had in the shop (about 5 of them), had a smaller footprint and was not as tall. It's especially small when you cut off the mounting lugs, which you don't need after you solder the legs in. I had a specific Carlon box I wanted it to fit in and it fits just perfectly. The RenSS's transformer would work, too -- although you'd have to redesign the board a little to make it fit, and it may be a bit taller, too... not sure...
Oh one other thing, on the WiRen all in one could the WiRen Module be moved to the far right in case an XBee with an SMA antenna was desired? Looking at the image again I guess there is enough space open on the power tie card and if the XBee was on the far right then the enclosure may be an issue for an external antenna.
You could probably turn it 90 degrees to the left and that would work. The PCB layouts for all those boards are in the copper section of the file library if you want to take a whack at them. They're in ExpressPCB format...
dirknerkle wrote:It was a transformer I had in the shop (about 5 of them), had a smaller footprint and was not as tall. It's especially small when you cut off the mounting lugs, which you don't need after you solder the legs in. I had a specific Carlon box I wanted it to fit in and it fits just perfectly. The RenSS's transformer would work, too -- although you'd have to redesign the board a little to make it fit, and it may be a bit taller, too... not sure...
Well that's a good reason.
