FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.5 K Views
Posts: 79
(@bobsmith)
Trusted Member
Joined: 11 years ago

The manufacturing is done, they should be shipping it today I think. They kind of "ooopsed" one of the boards, but it should be fine, but it caused a delay to contact me about it.

sw reg oops

Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

Ok, I have a problem trying to get DMX on a pb16. Last year I used a pb16 Mini to output my DMX signal to my RP AC controllers. I need to use a pb16 this year and I have one set up and a second one for inside testing and cannot for the life of me get a DMX signal off either one of them. I got my mini out, used the pb off my main controller and I get the signal. Put pb back on pb16 and no signal. I've swapped chips, reflow solder joints and still nothing. I should get 3vdc between d+ and ground right? The terminal block is a good place to check voltage but nothing, other than the 12vdc on block that it not part of the signal. Where to next? What am I doing wrong? Any help would be great.
Started a new thread about this problem HERE.


Reply
Posts: 113
(@cmndr-brain)
Estimable Member
Joined: 9 years ago

Well, per the norm, I'm late to the game. I have an extra E682 that I would like to experiment with. I'm assuming, even though the files are 2 years old, that the E684 gerber files v2 are correct. The bom in that github folder seems older and some of the stuff is out of stock or obsolete. Let's see what we can break.

Also, is the .bin file the same for the dedicated controller as it is for the E682 upgrade?

Last, does the speed of the EEProm make a difference? I see that Digikey is out of stock and the only ones I can seem to find are 400khz whereas the Digikey part number referenced in the bom is a 1Mhz


Reply
Posts: 544
(@jllracer55)
Honorable Member
Joined: 13 years ago
bobsmith wrote:The manufacturing is done, they should be shipping it today I think. They kind of "ooopsed" one of the boards, but it should be fine, but it caused a delay to contact me about it.

Will you have some extra to sell/or give a couple out, I could use 2 since the original vreg setup is out of stock.

Sent from my SM-A716U using Tapatalk


Reply
Posts: 79
(@bobsmith)
Trusted Member
Joined: 11 years ago

I should - I don't have them yet. They're sitting about 30 minutes away from me "delayed" - aka, I paid for the slower shipping, so they're going to make a point of not delivering it until the "slow tier" deadline (Tuesday) even though they could easily get them to me tomorrow (Friday) - and, they might actually deliver them Friday and surprise me - who can say for sure? Edited to add: Nope, just sitting there because today is "too early". DHL has done this with every shipment I've gotten from JLC - if it's the fastest method, even if it arrives at the local hub at 3PM, they put it on a delivery truck the same day and get it delivered, but if it's not the fastest tier service, it gets to the local hub and then sits for multiple days, just to prove a point I guess...

I'll post an update when I have them in my hands and tested a few. I mean there isn't much to screw up - it's just a switching regulator on a board with one diode, one inductor, and a couple resistors that make the voltage divider for the feedback to set the output voltage.


Reply
Page 83 / 126
Share: