Activity
 
Notifications
Clear all
bobsmith
@bobsmith
Trusted Member
Joined: Dec 8, 2015
Topics: 5 / Replies: 74
Reply
RE: Pixel Channel Demuxer / Splitter

Here's the last variant of the board. I wasn't sure I was going to bother doing the layout, as no one has actually expressed any interest at all, but ...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

In this context, it's also a moot point - just replace where I said "800" with "680" or whatever your pixels and controller support. It doesn't change...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

I've actually read the opposite - that 50us is the spec, but pixels actually detect reset pulse much faster than 50us... but that's just what I've rea...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

MartinMueller2003 wrote: You are forgetting the interframe gap of 350us Is that needed by the LEDs though? Nothing in the WS2811 spec says there ha...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

MartinMueller2003 wrote: Keeping in mind that no single port on a controller should be driving more than 680 pixels due to pixel data timing propagati...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

I don't see how the number of pixels changes anything on a long cable for the data line. As long as the data is valid at the first pixel, each pixel r...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

The other main point here is it allows much better use of each port on the actual controller, as well as simplifies power injection. It would be a com...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

The "long cable" issue is actually fairly easy to overcome, and I honestly don't understand why this is still an issue. I spent a few days looking at ...

3 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

After a few hiccups getting Design Blocks working properly in KiCad, I now have the more standard DIFF In / passthrough to 8 pixel output channel vers...

4 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

Oh, one other thing, if anyone knows the source for the shielded RJ45 jacks with the red inside that Falcon and Kulp use for the differential ports, I...

4 months ago
Forum
Reply
RE: Pixel Channel Demuxer / Splitter

Just a teaser... after MUCH work that took a LOT longer than I thought, the first board design is almost done - there's a few small things that need t...

4 months ago
Forum
Reply
RE: ESPixelStick Question for Martin

I'm talking about these ESP32-DevKitC with the old school ESP32-WROOM-32U modules on them that have external antennas. I know the ESP32-S3 isn't su...

4 months ago
Forum
Reply
RE: ESPixelStick Question for Martin

If you just fix that one line in "firmware/firmware.json" for the ESP32_KA firmware section, the java flash tool works just fine. I'd highly recommend...

4 months ago
Forum
Reply
RE: ESPixelStick Question for Martin

Another question, I see if I configure more than ~3000 pixels on various outputs, I start to see "[OutputMgr] ERROR: Too many output channels have bee...

4 months ago
Forum
Reply
RE: ESPixelStick Question for Martin

I wanted to try flashing the ESP32_KA version, as it has 8 outputs already defined, and from what I can tell is just a generic ESP32, but I want to tr...

4 months ago
Forum
Page 1 / 6
Share: