FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.9 K Views
Posts: 19
(@ukdel)
Eminent Member
Joined: 10 years ago

yes the display does hang from the back..it doesnt have any fixings apart from the connection pins.. but can be moved else where by using flying leads.


Reply
Posts: 19
(@ukdel)
Eminent Member
Joined: 10 years ago

I have the BBB16, with expansion and differential reciever output and they all work great.. (note there is a bit of a modification to do for the BBB16 v2 board to get the GPIO, display and buttons working).

The question is about DMX. I am using a cheap 12 Channel DMX decoder(WS-DMX-12CH-XB22) trying to run some RGB LEDS (not addressable WS28xx) and cannot seem to get it to work. I dont have any other source of DMX signal to check the decoder but it does run the RGB LEDs on a fixed display setting. I was runnin the DMX sequence from XLightss (through the BB16 in bridge mode). I think I set the DIP switches correctly on the decoder for the channel setting. Connecting the decoder from BB16, I have tried both DMX 1 and 2 from the RJ45 and the DMX2 from the set of connectors.

I used the simple DMX tester (two LED wired across the D+ D- and GND) and whilst D- gave an indication of a signal the other (D+) was a solid light.. which if I interpret correctly, can indicate a lack of proper DMX signal.

I am stumped .. anyone suggest a better way to test the output from the board, or something to check the decoder is working with a DMX signal? Appreciate any help you can give. Thanks


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago
scooter_seh wrote:I have been working on a Smart Receiver. The Smart Receiver is still very much a work in progress. My plan was to make a 12 output receiver with all "A, B, & C" outputs all on one PCB. I am having issues with the firmware, I cannot get it working on the STM32 Nucleo dev board. I have no real embedded programming experience besides Arduino, so it has been a challenge fo me. After the Pi Pico was released, I started redoing the Smart Receiver to use the Pico as I thought it may be easier. I still don't know what direction is better the STM32 or the PI Pico. If anyone has any thoughts or suggestions, please let me know.

Thanks,
Scott

You're trying to do this on an STM32 Nucleo??? Those things are freakin' insane to program. The learning curve is nuts. Anything you can do on an ESP32 or Pi (for purposes of this board), take the same problem and expend about 5 times the effort, and that's what it'll take to do it on an STM32. I don't know why ST Micro makes things so complicated.


Reply
Posts: 19
(@ukdel)
Eminent Member
Joined: 10 years ago

update ... Well i tested the decoder with a USB/DMX dongle and was able to eliminate that from being the problem. SO this points back to the output from the BBB16 board. It is probably a simple config issue but like I said I have tried most things. If anyone has this board and got the DMX working would appreciate any tips. Regards


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

Double check the DMX pin out on the board. Go to gethub and look up that board and look at the PDF file that has the wiring connections on them. There was a boo boo on the PB16 Mini. Don't remember right off but it may have been positive and negative were reversed or on different pins I don't remember but worth looking into.


Reply
Page 67 / 126
Share: