FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.5 K Views
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

No technical reason other than using about half the holes to solder.

Curtisfeatures wrote:Thinking about this further. Is there a reason to use network resisters rather than "traditional" Carbon film ones if they are just going between ports 1-2 3-4 and so on? Is it just for convenience?

Reply
Posts: 16
(@curtisfeatures)
Active Member
Joined: 7 years ago
ukewarrior wrote:No technical reason other than using about half the holes to solder.

Same amount of solder holes, just takes up more room on the board. I have knocked up a small PCB so i can make my own network resisters that will slot in the same ports if i wish to go down that route.


Reply
Posts: 36
(@supergumby)
Eminent Member
Joined: 17 years ago

For the 3-pin connectors I used THESE and straightened the pins.

Don


Reply
Posts: 16
(@curtisfeatures)
Active Member
Joined: 7 years ago

So i just opened ebay and a suggested item was exactly the part i was looking for - How bizarre!

Screenshot 2020 12 04 at 16.13.27

Reply
wilmar
Posts: 2115
(@wilmar)
Noble Member
Joined: 8 years ago
Curtisfeatures wrote:So i just opened ebay and a suggested item was exactly the part i was looking for - How bizarre!

They listen to you through your. Phone
Lol

Sent from my iPhone using Tapatalk


Reply
Page 55 / 126
Share: