FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.5 K Views
Posts: 447
(@glycerine)
Honorable Member
Joined: 7 years ago
Curtisfeatures wrote:Same amount of solder holes, just takes up more room on the board. I have knocked up a small PCB so i can make my own network resisters that will slot in the same ports if i wish to go down that route.

I'd almost rather do this in the future. The resistor arrays that I got didn't seem to quite make all of the connections when pushed into the "carrier". I ended up taking small needle nosed pliers and putting a small curve on each pin. They seem to work fine now.
I wondered why these are made to be removable. Do resistor arrays have a short life span?


Reply
Posts: 16
(@curtisfeatures)
Active Member
Joined: 7 years ago
Glycerine wrote:I'd almost rather do this in the future. The resistor arrays that I got didn't seem to quite make all of the connections when pushed into the "carrier". I ended up taking small needle nosed pliers and putting a small curve on each pin. They seem to work fine now.
I wondered why these are made to be removable. Do resistor arrays have a short life span?

I can send you the gerber files for the pcb if you like. It’s literally 4 resisters I line with holes for a right angled set of pins.

Sent from my iPhone using Tapatalk


Reply
Posts: 57
(@aclarksr)
Trusted Member
Joined: 13 years ago


Thank you for a great project. This is my daughter and son-in-law’s starter kit (my yard is pretty full). Currently only running two spiral trees and four arches, lots of room to expand.

Sent from my iPad using Tapatalk


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

I'd like to see those gerbers!

Curtisfeatures wrote:I can send you the gerber files for the pcb if you like. It’s literally 4 resisters I line with holes for a right angled set of pins.

Sent from my iPhone using Tapatalk


Reply
Posts: 16
(@curtisfeatures)
Active Member
Joined: 7 years ago
ukewarrior wrote:I'd like to see those gerbers!

Here you go. Nothing special 🙂
https://github.com/CurtisFeatures/PCBs/tree/main/DIY-Isolated%20Network%20Resistor


Reply
Page 56 / 126
Share: