On all the expansion boards I have been wiring the header this way as in most cases it is easier to wire. The needed pins are away from the notch so it is normally easier to route. For this board this did causes the routing to be more channeling as all the nets are filliped. I like your idea so I filliped the header and rerouted everything. It removed all the vias too which I like better. I think I may go though and update the other boards as well. I updated the 16_Expansion files on github with this.
Thanks,
Scott
Supergumby wrote:I think i may have found an issue with the 16_Expansion. I had envisioned the expansion board sitting back-to-back with the PB16 controller, so I ordered generic 4" ribbons. However, with the position of the 40-pin header - as shown in the silkscreen, a short cable positions the expansion directly above and parallel to the PB16 (or, below and inverted).If the header was rotated 180 degrees on the expansion board, it would work (for me). I'm not sure what that would do to your netlist, or if this is even possible.
Don
scooter_seh wrote:. I updated the 16_Expansion files on github with this.Thanks,
Scott
Five more boards ordered..... In BLUE this time. :thup:
Thanks Scott
Probably a naive question but are these designed for 1 or 2 ounce copper boards?
1 ounce
aclarksr wrote:Probably a naive question but are these designed for 1 or 2 ounce copper boards?
Scott,
The new 16_Expansion layout is perfect. I see that you have flipped the headers on the remaining expansion boards as well.
To complete the PB16 DIY controller family, what would be your interest in mocking up a four-out Differential Receiver board?
Don

