FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.5 K Views
Posts: 3
 oddi
(@oddi)
New Member
Joined: 9 years ago

Hey guys
can i use the micro USB port on pocket beagle to attach a WiFi dongle using otg adapter


Reply
Posts: 36
(@supergumby)
Eminent Member
Joined: 17 years ago

Two 16 Port Expansion boards assembled. Tomorrow we test.

16 Expansion

Reply
Posts: 87
Topic starter
(@scooter-seh)
Trusted Member
Joined: 12 years ago
oddi wrote:Hey guys
can i use the micro USB port on pocket beagle to attach a WiFi dongle using otg adapter

No, you need a small USB hub, The USB port has limited power so I only use a two port hub.


Reply
Posts: 87
Topic starter
(@scooter-seh)
Trusted Member
Joined: 12 years ago
Supergumby wrote:Two 16 Port Expansion boards assembled. Tomorrow we test.

Black is not allowed:wow:


Reply
Posts: 36
(@supergumby)
Eminent Member
Joined: 17 years ago

I think i may have found an issue with the 16_Expansion. I had envisioned the expansion board sitting back-to-back with the PB16 controller, so I ordered generic 4" ribbons. However, with the position of the 40-pin header - as shown in the silkscreen, a short cable positions the expansion directly above and parallel to the PB16 (or, below and inverted).

If the header was rotated 180 degrees on the expansion board, it would work (for me). I'm not sure what that would do to your netlist, or if this is even possible.

Don


Reply
Page 12 / 126
Share: